K. Gargul, P. Handzlik, P. Palimąka, A. Pawlik

The Application of citric acid solutions for selective removal of zinc from steelmaking dust

J. Min. Metall. Sect. B-Metall., 57 (2) (2021) 163-173 DOI:10.2298/JMMB200630012G
Full text (pdf)

Export manuscript information:
RIS Format (EndNote, Reference Manager), BibTeX
Available online 22 January 2021
(Received 30 June 2020; Accepted 16 January 2021)
doiSerbia

Abstract

Steelmaking dust is one of the wastes which are produced by ironworks. This kind of waste is a byproduct produced mainly in electric arc furnace. Zinc content in dust is different and depends on the charge processed in the furnace. The basic technology used for recycling steelmaking dust is Waelz process, however, it requires a large amount of reducer and generates a lot of waste which needs to be stored. First stage in this study was to analyze if steelmaking dust was safe to be exposed to atmospheric conditions. To verify this, the dust was subjected to two kinds of standard leaching tests, TCLP and EN-12457-2. The amount of extracted elements was considerable and that was why steelmaking dust should be treated as dangerous waste. Leaching in citric acid solutions was divided in four series. The first one was set to determine the time and temperature for most selective zinc leaching. Next series optimized three leaching parameters which were: citric acid concentration, liquid to solid phase ratio (l/s), and the stirring speed. Performed experiments showed the optimal conditions for selective leaching: temperature of 50 °C, leaching time of 60 minutes, citric acid concentration of 0.5 mol/dm3, l/s ratio of 10, and stirring speed of 250 rpm.

Keywords: Steelmaking dust; Citric acid; Zinc recovery; Leaching

Correspondence Address:
K. Gargul,
AGH University of Science and Technology,
Faculty of Non-Ferrous Metals,
Kraków, Poland,
email: krzygar@agh.edu.pl

 

 

Creative Commons License
This work is licensed under a
Creative Commons Attribution-
ShareAlike 4.0 International License