TY - JOUR T2 - Journal of Mining and Metallurgy, Section B: Metallurgy TI - Evaluation of en AW-5083 aluminum alloy homogeneity using statistical analysis of mechanical properties VL - 53 IS - 3 SP - 429 EP - 439 PY - 2017 DO - 10.2298/JMMB170812046D AU - N. Dolić AU - Z. Zovko Brodarac AD - University of Zagreb, Faculty of Metallurgy, Sisak, Croatia; AB - In the frame of this investigation, the homogeneity of six (6) ingots of aluminum alloy EN AW-5083 cast by semi-continuous vertical Direct Chill casting (DC) Process was investigated correlating mechanical properties in as-cast and homogenized condition. The investigation followed the static design of the Latin square. Determination of the ultimate tensile strength and elongation across the cross-sectioned sliced at the ingots’fronts and rears in as-cast state revealed differences per cross section of each particular slice. Comparison of obtained differences enabled evaluation of mechanical properties homogeneity of the ingots as a whole. The influence and significance of homogenization was also quantified correlating the mechanical properties results for as-cast and homogenized state at the front and rear position in ingot. The results were processed using the StatSoft® STATISTICA 13.2 software package using charge, slice height and slice width as sources of variability. Comparison of obtained statistical results for both states respectively in respect to the sampling position enabled estimation of homogenization process influence on mechanical properties. KW - Aluminium Alloy EN AW-5083 KW - Direct Chill Process KW - Ultimate Tensile Properties KW - Elongation N1 - Correspondence Address: N. Dolić, University of Zagreb, Faculty of Metallurgy, Sisak, Croatia ndolic@simet.hr N1 - J. Min. Metall. Sect. B-Metall. 53 (3) B (2017) 429-439. DOI:10.2298/JMMB170812046D PB - Technical Faculty in Bor SN - 14505339 (ISSN) LA - English J2 - J. Min. Metall. Sect. B Metall. M3 - Article ER