Special issue dedicated to memory of Professor Dragana Živković - vol. 53 (3) B - 2017

S. Delsante, D. Li, R. Novakovic, G. Borzone

Design of Ag-Ge-Zn braze/solder alloys: experimental thermodynamics and surface properties

J. Min. Metall. Sect. B-Metall. 53 (3) B (2017) 295-302. DOI:10.2298/JMMB170626036D
Full text (pdf)
Export manuscript information:
RIS Format (EndNote, Reference Manager), BibTeX

Abstract

The experimental investigation of the Ag-Ge-Zn phase diagram was performed by using combined microstructural and Differential Scanning Calorimeter (DSC) analyses. The samples were subjected to thermal cycles by a heat-flux DSC apparatus with heating and cooling rate of 0.5 or 0.3 °C/min. The microstructure of the samples, both after annealing and after DSC analysis, was studied by optical and scanning electron microscopy coupled with EDS (Energy Dispersive Spectroscopy) analysis. Considering the slow heating and cooling rate adopted, the isothermal section at room temperature was established. No ternary compounds were observed. On the basis of the experimental investigations the invariant reactions were identified. Combining the thermodynamic data on the Ag-Ge, Ag-Zn and Ge-Zn liquid phases by means of Butler’s model the surface tension of Ag-Ge-Zn alloys was calculated.
Keywords: Ag-Ge-Zn; Solder alloys; Differential scanning calorimetry; Liquidus projection; Isothermal section; Surface tension
Correspondence Address:
G. Borzone,
Department of Chemistry and Industrial Chemistry,
Genoa University and Genoa Research Unit of INSTM, Genoa, Italy;
Institute of Condensed Matter Chemistry and Energy Technologies,
National Research Council (ICMATE-CNR), Genoa, Italy
This email address is being protected from spambots. You need JavaScript enabled to view it.
Creative Commons License
This work is licensed under a
Creative Commons Attribution-
ShareAlike 4.0 International License